MiniDSP miniDC Isolator

Beschikbaarheid: Niet op voorraad
Levertijd: 2-4 weken

De miniDC zorgt voor storingsvrije 12V voeding voor de miniDSP daar waar dat meestal lastig is, bijvoorbeeld in de auto en biedt tevens een vertraagde 12V remote/trigger voor het aan/uit zetten van de eindversterkers.

miniDC isolator is a tiny board allowing a perfect system integration with power on/off of your DSP and amplifier system. Based on a DC-DC isolated converter and delay circuit, it allows you remote turn ON/OFF in the correct order. This board is especially recommended for car audio application to allow complete isolation of the alternator noise. It is compatible with all miniDSP products except the miniDSP 2x8/8x8 units.

The diagram in the datasheet illustrates the timing relationship between Vin, Vout, REMin and REM out pins. When the remote input (REM in) goes high (above 5V), the device will the isolated 12V output immediately (no delay). The remote output (REM OUT) is delayed by 3 seconds to allow for the DSP to settle before amplifiers are turned on. Once the remote input (REM in) signal goes low, the remote output goes immediately low to turn the amplifier off first. The isolated 12VDC out will be delayed to turn the miniDSP last.

 

Technical Specifications

  • 12V DC to DC isolation compatible with miniDSP unbalanced and balanced units
  • Wide 10-18V input range
  • 1500V isolation
  • Short circuit protection
  • Delayed +12V remote out

 

Downloads:

 

NOTE: This product is not compatible with the miniDSP 2x8/8x8 platforms since it does not have enough power.

0 sterren gebaseerd op 0 beoordelingen
Door het gebruiken van onze website, ga je akkoord met het gebruik van cookies om onze website te verbeteren. Dit bericht verbergen Meer over cookies »